Xi’an Dechuang Electrical Technology Co., Ltd.
中文     English    
  News  
Industry News
Company News
Site Notice
  联系我们  
公司总机
029-88609367
029-88606479
雷达物位计专线
029-89196814
029-89288673
 
Industry News
Instrument knowledge|How to choose the correct type of guided wave radar level gauge?
Views:   ·  source:Xi’an Dechuang Electrical Technology Co., Ltd. ·  author:西安德创电气科技有限公司 ·  Release date:2021-05-11 09:43:04

Guided wave radar level gauge, a liquid level measuring instrument in industrial production, is based on the time domain reflection principle (TDR) to complete the continuous level measurements of liquids, particles and slurry. Widely used in water storage tanks, acid and alkali storage tanks, slurry storage tanks, solid particles, small oil storage tanks, various conductive, non-conductive media, corrosive media such as coal bunkers, ash bunkers, oil tanks, acid tanks, etc. .

So how to correctly choose the guided wave radar level gauge? Please see the following key selection points:


1.Confirm the viscosity of the measuring medium

When selecting a guided wave radar level gauge, the viscosity of the measuring medium must be confirmed. If the measuring medium is very viscous, it is not suitable to use the guided wave cable pole. This kind of contact measurement method, hanging material will affect the signal transmission and reception and generate false signals.

2.Confirm the causticity of the measured medium

If the measured medium is a corrosive liquid, it is necessary to use a wave guide cable sleeve PTFE or FEP material.


3.Definition of range

The range of the guided wave radar level gauge is the vertical distance from the mounting flange surface to the bottom of the tank. At the same time, reserve the lowest probe of the cable at least 30mm from the bottom of the tank to ensure that the probe does not touch the bottom of the metal tank to generate interference signals. The cable can be reserved a little longer, you can cut it by yourself, but if you break it, you need to re-customize the cable. Therefore, we must confirm the length of the cable clearly when determining the technical parameters, so as to avoid the on-site measurement.

In addition, it is especially important to note that for the guided wave radar level meter with sleeve PTFE or FEP material products, the cable length cannot be shortened once confirmed

4.Confirm whether there is stirring

Select the guided wave radar level gauge to confirm whether there is stirring in the storage tank, where is the position of the fan blade, the blade is very close to the pipe wall, it is not suitable to use the guided wave radar level gauge, or add a bypass tube to measure. The cable or pole should be at least 300mm away from the pipe wall.

5.Confirm the dielectric constant of the measuring medium

If the measured dielectric constant of the liquid medium is very low, you can refer to the use of guided wave double cable or guided wave coaxial radar level gauge, the effect will be better.

6.Fixing the probe tip of radar level gauge

If the probe tip needs to be fixed, there are two kinds of fixing methods: insulated and non-insulated.

(一)Insulation fixing refers to the insulation fixing method when the measured dielectric constant is low and fixed on the bottom of the metal tank

(二)Non-insulating fixing refers to the non-insulating fixing method used when the dielectric constant of the measured medium is high and the tank is a metal material, a material with a low dielectric constant or a material very close to the dielectric constant of the measured medium.


Any inquiry of radar level meter, welcome to contact us!

 
Copyright © 2022 Xi’an Dechuang Electrical Technology Co., Ltd. All Rights Reserved.
Address: 3-10401, East Zone, Modern Enterprise Center, No.2 Zhangba Wu Road, Yanta District, Xi
Phone: 86-29-88606479    Email: xadckj@163.com